Передачи в ручном режиме отлично переключаются
Вот что я нашел на сайте у РОССА
Note: The following advanced operations are intended for a stock 90-hp A4 TDI (ALH engine). Expect some variations if you have an A3/B4 car (A3 Jetta, Passat).
Special adaptations: Login code 12233:
These procedures do NOT apply to the PD engines!
• To perform the following adaptations (except idle) you need to use the Login function.
• Enter 12233 as a Login code.
• Misuse of some of the adaptations can lead to engine failure.
• This is done at your own risk!
• Note that the EGR setting is for off-road use only...
[Select]
[01 - Engine]
[Login - 11]
Enter 12233 to activate special adaptations,
[Do It!]
[Adaptation - 10]
Enter the "channel number" below to select each channel.
Put in the suggested value(s) in "new value".
[Test]
Observe the "test value" field to make sure the adaptation setting is acceptable.
[Save]
Channel 1: injected quantity
• Check the injected quantity at idle, engine warm and all power consuming devices turned off.
• Specification is 2.5 to 9 mg/h.
• To change the amount of injected fuel perceived by the ECU, go to adaptation channel 1.
• If you have driveability problems, you may want to increase it to 3-4 mg/h.
• For slightly improved throttle response, you may try to decrease the value.
Channel 2: idle speed
• No login required
• The stock adaptation value should be 32768 (corresponds to 903 rpm).
• Increase or decrease this to change idle speed.
Channel 3: EGR
• To decrease the EGR rate, increase the number to the highest possible value (typically 33768).
• This will prevent/slow down the intake manifold clogging problem and reduce smoke.
• Though the MAF at idle is still within specifications (370 mg/h) do not use this adaptation on the road
• Again, this EGR setting is for off-road use only !!!
Channel 4:
• Don’t mess with it!
Channel 5: starting conditions
• Though undocumented, this channel effects the injected quantity the ECU allows when starting.
• You may want to experiment with it as a temporary fix for bad-start problems
Channel 18:
• On some EDC-15 ECUs, this channel has a non-zero value in it like 190.
• Yes, that's the "speed limiter". Don't mess with it!
• It can only be adjusted downward, and it's one-way! You cannot increase the value, and if you decrease it, you're stuck with it.
• So unless you want to permanently decrease your car's top speed, Don't mess with it!
• If you do mess with it and your car ends up with a lower top speed than it had before, don't call us, don't e-mail us, and don't complain that we didn't warn you!
Вот 18 канал это то что он мне поменял
